Recent content by eboynton

I got the pre cut ceramic tint from chad at utvwindowtint.com and it went on smoothly. (I’m no installer by any stretch)

nice, that is exactly what I’m looking for. Thanks

Anyone bought the rear window and upper and lower cab close offs for an Xpedition non ADV and fit them into the ADV model to close it off?

No not yet

Anyone found molle window coverings for the outside of the rear side windows on an ADV? I want to add RotoPax fuel cans on the outside of the vehicle but have only found 2 options for rear side window molle and they only mount on the inside. Thanks

Does anyone know what Polaris is actually doing to the clutch? Is it just weights and a spring kit on the primary? I’d have to drag mine 200 miles to the dealer to get it done plus kill an entire day, if all they’re doing is a couple weights and a spring I might opt for the gilomen it’s only...

I haven’t called to find out if they will fit. But I’d bet they will fit with little to no modification. I’ve seen a couple videos out there people posted using cab shocks for a semi truck and they fit just using a couple washers to fill in the gaps on the mounting brackets. I’d just rather use...

Looking at switching out the sold links for some walker links on the rear sway bar. Anyone done anything like this? I’m thinking it should provide better articulation without sacrificing body roll.

Have you installed this boot yet? Curious if it works or not. Please post a pic if you have any. Thanks

I use the bar just under the winch to hook the ratchet straps too, to tie down the front.

Here’s what I did, works pretty well. The factory mat still fit in and locked down. The passenger seat was a little tight but went in.

Just take down the rear skid plate and easily move it if needed.

I have the adv2. I pushed it up and zip tied it up out of the way.