Recent content by Ryan

I can tell you one thing... There is absolutely no comparison... I started with the AA Stage II tune and clutch, then went to the turbo. The turbo hands down rocks and the performance from 0 to 60MPH with the turbo cuts the time in half. It a huge performance upgrade (my times are posted...

Icehog, Now that its been a while what's your lasted opinion on the speedwerx setup?

Thanks guys, the dealer is replacing the EPS. It took showing them the video to agree there was a problem.

Same low heat temps as well. Sitting still its awful. I have not done any real digging but does any one have the burping/bleeding process documented or know where we can find it?

Thanks, I have 32 Valor Alphas. I just looked at this video. Its not even close. There's def a problem.

Fellas, need your help to ensure im not going crazy. My steering has seemed to have gotten really tough to turn when the machine is sitting still (grass or pavement). So much that it takes 2 hands and a lot of force to turn the wheel. The dealer said Polaris has a bulletin and they needed to...

Hey Ed, did you have to build a custom mount? I have a full hydraulic lightweight swoway plow and I'm thinking about doing the same thing.

Love my SRS springs and end caps. Its true ride hieght and spec for the shocks. I did have to slightly adjust the rears after 500 miles. 1/4 of an inch tighter. I do carry about 200lbs of tools but it rides great. You'll love the upgrade.

I got it for rolling up long mountain hills on the east coast with a loaded cab full of tools. The difference is night and day, I don't feel like its running out of steam anymore. The AA Turbo and SRS springs w/res end caps are my two best mods, without a doubt..

Here are the Polaris Part numbers for the switches: Is your part number for the connector the aux switch plugs into? Just trying to make sure. Headlight Switch 4080801-01 AWD /Turf Switch 4080801-02 AWD Switch 4080801-03 Front Bumper Light Switch 4080801-06 Hazard Switch 4080801-08 Horn...

I did my windshield at 50% with ceramic tint, it certainly blocks the heat. Buddys say they can barely see me inside but 50% is light enough to not cause any visibility issues at nighttime.

Yes, you can replace\upgrade the end caps with Schrader valve caps. There are many out there. I have read that some have experienced empty or very low PSI on new shocks. MTS Off-Road Schrader Valve Reservoir Caps (FOR FOX SHOCKS)

The Schmidty (SRS) spring kit and 200 psi of nitrogen is a must. It gave me back the 3 inches of sag and the machine rides so much better than it did with stocks springs new. (which wasn't bad from a ride perspective) It was one of my best upgrades. I haven't pulled the trigger on long travel...

If it were me, and I hope it is someday soon, I would wait for Sandcraft. That thing is impressive. Did you check resellers like Fueled? They look like they have them.

Love that place, you can ride hundreds of miles and never hit the same trail twice.